Wireless Access Point FreeBSD - Revision history

Heth: moved Wireless hotspot FreeBSD to Wireless Access Point FreeBSD

2012-05-08T07:14:59Z

moved Wireless hotspot FreeBSD to Wireless Access Point FreeBSD

Heth at 07:28, 10 March 2011

2011-03-10T07:28:28Z

Heth: /* Script */

2011-01-25T14:33:53Z

‎Script

Heth: /* ifconfig after script */

2011-01-25T14:29:11Z

‎ifconfig after script

Heth: Wireless hotsport FreeBSD moved to Wireless hotspot FreeBSD

2011-01-07T06:26:39Z

Wireless hotsport FreeBSD moved to Wireless hotspot FreeBSD

Heth at 12:00, 4 January 2011

2011-01-04T12:00:59Z

Heth: New page: Cisco AIR-PI21AG-E-K9 adapter installed. FreeBSD installs right driver ==RC.CONF== ifconfig_em0="dhcp" gateway_enable="YES" dhcpd_enable="YES" ipnat_enable="YES" # Start ...

2011-01-04T12:00:31Z

New page: Cisco AIR-PI21AG-E-K9 adapter installed. FreeBSD installs right driver ==RC.CONF== <source lang=cli> ifconfig_em0="dhcp" gateway_enable="YES" dhcpd_enable="YES" ipnat_enable="YES" # Start ...

New page

Cisco AIR-PI21AG-E-K9 adapter installed. FreeBSD installs right driver
==RC.CONF==
<source lang=cli>
ifconfig_em0="dhcp"
gateway_enable="YES"
dhcpd_enable="YES"
ipnat_enable="YES" # Start ipnat function
ipnat_rules="/etc/ipnat.rules" # rules definition file for ipnat
</source>

==ifconfig before script==
<source lang=config>
[root@ /etc]# ifconfig
em0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
options=219b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM,TSO4,WOL_MAGIC>
ether 70:f3:95:08:46:c7
inet 192.168.139.51 netmask 0xffffff00 broadcast 192.168.139.255
media: Ethernet autoselect (1000baseT <full-duplex>)
status: active
ath0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> metric 0 mtu 2290
ether 00:40:96:b2:b3:75
media: IEEE 802.11 Wireless Ethernet autoselect (autoselect)
status: no carrier
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> metric 0 mtu 16384
options=3<RXCSUM,TXCSUM>
inet6 fe80::1%lo0 prefixlen 64 scopeid 0x3
inet6 ::1 prefixlen 128
inet 127.0.0.1 netmask 0xff000000
nd6 options=3<PERFORMNUD,ACCEPT_RTADV>
</source>
==Script==
Running the script below
<source lang=cli>
#from man ath
#Se http://www.freebsd.org/doc/handbook/network-wireless.html
ifconfig wlan0 create wlandev ath0 wlanmode hostap
ifconfig wlan0 inet 10.168.139.1 netmask 0xffffff00 ssid FreeBSD weptxkey 1 wepmode on wepkey 1:0x1234567890 mode 11g
sysctl net.inet.ip.forwarding=1
</source>
==ifconfig after script==
<source lang=cli>
em0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
options=219b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM,TSO4,WOL_MAGIC>
ether 70:f3:95:08:46:c7
inet 192.168.139.51 netmask 0xffffff00 broadcast 192.168.139.255
media: Ethernet autoselect (1000baseT <full-duplex>)
status: active
ath0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 2290
ether 00:40:96:b2:b3:75
media: IEEE 802.11 Wireless Ethernet autoselect mode 11g <hostap>
status: running
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> metric 0 mtu 16384
options=3<RXCSUM,TXCSUM>
inet6 fe80::1%lo0 prefixlen 64 scopeid 0x3
inet6 ::1 prefixlen 128
inet 127.0.0.1 netmask 0xff000000
nd6 options=3<PERFORMNUD,ACCEPT_RTADV>
wlan0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
ether 00:40:96:b2:b3:75
inet 10.168.139.1 netmask 0xffffff00 broadcast 10.168.139.255
media: IEEE 802.11 Wireless Ethernet autoselect mode 11g <hostap>
status: running
ssid FreeBSD channel 7 (2442 MHz 11g) bssid 00:40:96:b2:b3:75
regdomain 55 indoor ecm authmode OPEN privacy ON deftxkey 1
wepkey 1:40-bit txpower 20 scanvalid 60 protmode CTS wme burst
dtimperiod 1 -dfs
</source>
[[Category:FreeBSD]][[Category:Network]]

← Older revision	Revision as of 07:14, 8 May 2012
(No difference)

@@ Line 11: / Line 11: @@
 ==ifconfig before script==
 <source lang=cli>
-[root@ /etc]# ifconfig
+[root@ /etc]# <input>ifconfig</input>
 em0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
          options=219b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING,VLAN_HWCSUM,TSO4,WOL_MAGIC>
@@ Line 18: / Line 18: @@
          media: Ethernet autoselect (1000baseT <full-duplex>)
          status: active
-ath0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> metric 0 mtu 2290
+<notice>ath0</notice>: flags=8802<BROADCAST,SIMPLEX,MULTICAST> metric 0 mtu 2290
          ether 00:40:96:b2:b3:75
          media: IEEE 802.11 Wireless Ethernet autoselect (autoselect)
@@ Line 34: / Line 34: @@
 #from man ath
 #Se http://www.freebsd.org/doc/handbook/network-wireless.html
-ifconfig wlan0 create wlandev ath0 wlanmode hostap
+<notice>ifconfig wlan0 create wlandev ath0 wlanmode hostap</notice>
 ifconfig wlan0 inet 10.168.139.1 netmask 0xffffff00 ssid FreeBSD weptxkey 1 wepmode on \
 wepkey 1:0x1234567890 mode 11g channel 1
@@ Line 58: / Line 58: @@
          inet 127.0.0.1 netmask 0xff000000
          nd6 options=3<PERFORMNUD,ACCEPT_RTADV>
-wlan0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
+<notice>wlan0</notice>: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
          ether 00:40:96:b2:b3:75
          inet 10.168.139.1 netmask 0xffffff00 broadcast 10.168.139.255

@@ Line 35: / Line 35: @@
 #Se http://www.freebsd.org/doc/handbook/network-wireless.html
 ifconfig wlan0 create wlandev ath0 wlanmode hostap
-ifconfig wlan0 inet 10.168.139.1 netmask 0xffffff00 ssid FreeBSD weptxkey 1 wepmode on wepkey 1:0x1234567890 mode 11g
+ifconfig wlan0 inet 10.168.139.1 netmask 0xffffff00 ssid FreeBSD weptxkey 1 wepmode on \
 sysctl net.inet.ip.forwarding=1
 </source>
 ==ifconfig after script==
 <source lang=cli>

@@ Line 65: / Line 65: @@
          wepkey 1:40-bit txpower 20 scanvalid 60 protmode CTS wme burst
          dtimperiod 1 -dfs
 </source>
 {{Source cli}}
 [[Category:FreeBSD]][[Category:Network]]

← Older revision	Revision as of 06:26, 7 January 2011
(No difference)